![]() ![]() ![]() Plug the bore and chamber with wadded up paper towel. So you bought a Chicom SKS at the flea market for 100$ a few years back,the bluing is thin or gone and it has a few pits under the wood line and the stock looks like a board that was drug behind a pickup down a gravel road so you oiled it up and used it for a trunk gun.its time to take that clunky thing and turn it into something to be proud of!ĬOMPLETELY Strip your rifle, remove the trigger group and gas system and cover the parts that meet the stock in lithium grease as well as the trigger group.Now we get to the grease the barrel channel and mask off the cleaning rod cut with duct tape, about an inch wide should do, and using a rotary tool drill a bazillion shallow holes along the barrel channel.next mix equal parts of hardener and epoxy resinand mix in a big pinch or Iron filings and using a Popsicle stick,smear it into the barrel channel.Now take the barreled action covered in grease and the trigger group and re assemble and wipe away any s not necessary or even too awful smart to put the gas system back on at this point.allow to cure over night.
0 Comments
Leave a Reply. |